Attaching Vinyl Siding To Concrete

So if i furred the new siding i d have a lot of patching and filling to do and it d probably look funky.

Attaching vinyl siding to concrete. The concrete foundation is nearly flush with the first floor siding meaning that using furring strips would cause the new siding to stick out. It slips into the groove between adjoining slats and once it clicks into place you can hang items as heavy as 12 pounds. Step 3 attach a vinyl panel starter strip. Measure the width of one block wall and cut treated two by fours to match.

Install a strip of insect netting along the bottom edge of the concrete wall by nailing the. The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor. The strips can be ripped from 2 inch by 4 inch lumber or plywood but they should be at least 3 4 inch thick. In effect i would need to add a bit of spacing between the concrete and the siding.

I d like to attach the siding directly to the concrete here. How to install siding on concrete block house. Draw a line on the wall along the top of each siding course before you pull the nails. Another poster mentioned remington rounds for fastening.

Snap a horizontal line at the lowest point on your garage wall. Most hooks are stainless steel so they won t corrode and they are easy to remove when you re done with them. Slide the zip tool under the butt edge of the siding hook the locking edge and pull down. Insert sleeve anchors then attach other furring strips as you did with the first one and tighten the sleeve anchors.

The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house. Using self tapping screws such as those by tapcon will fasten the strips to the concrete securely but concrete nails can be used as well. Lift the unlocked siding to expose the nailing hem of the siding piece below. Install the boards horizontally placing them flat against the.

Installing 2 inch wide treated strips is necessary for a solid base for the house siding. The existing siding is flush with the concrete. Nail 1 1 2 inch thick wooden furring strips to the concrete wall at 4 foot intervals using concrete nails. Then slide the tool horizontally along the lock to release it.

The number of strips you need. Attach the boards to the block by holding them in position you ll need an assistant and drilling through the boards and the. The easiest and safest way to hang something from vinyl siding is to use a siding hook.